Take a deep dive into the world of scan tools with Matt Fanslow, Keith Perkins, Tanner Brandt, and Richard Falco. Together they discuss choosing the right scan tool, maximizing scan tool usage, aftermarket vs. factory scan tools, the power of scan data, subscription fees, the future of diagnostics, AND MORE! Show Notes:The best scan tool? (00:02:22) Discussion on the different types of scan tools and their suitability for specific tasks, such as graphing or coding.Factors to consider when choosing a scan tool (00:05:09) Consideration of the specific needs of the job, including the type of vehicle and the required functionalities, when selecting a scan tool.Increase in non-drivability issues (00:06:51) Discussion about the growing number of non-drivability issues in vehicles, such as electrical, electronic, and climate control problems.Underutilization of scan tools (00:08:23) The importance of utilizing the full potential of scan tools and highlights the lack of knowledge and usage among technicians.Importance of following service procedures (00:10:39) The discussion revolves around the consequences of not following service procedures, leading to shortages of parts and damage to vehicle components.The difference between aftermarket and factory scan tools (00:14:04) Explains the difference in network topology and module pinging between aftermarket and factory scan tools.Module topography and caution with aftermarket scan tools (00:15:26) Discusses the addition of module topography in some scan tools and warns against relying solely on aftermarket scan tools for network layout.Challenges with J 2534 Device vs. Factory OEM Interface (00:23:09) The difficulties of using a J 2534 device instead of the factory interface for vehicle diagnostics and repairs.Communication Challenges in the Automotive Industry (00:27:34) The complex communication networks and different teams involved in engineering and dealership software in car companies.Aftermarket tools for relative compression test (00:30:06) Exploration of aftermarket tools, specifically the E-Scan Elite by ATS, that can perform a relative compression test.Determining the number of modules in a car (00:32:17) Methods for figuring out the number of modules in a car, including using the VIN, RPO codes, and factory scan tools or service information.Throttle Position and Tuners (00:36:01) Discussion on using average throttle position to detect tuners in Chrysler vehicles.Deleted Engines and Missing AFM (00:36:57) Exploration of issues with deleted engines and missing AFM codes after reprogramming.Scan Data and Power Complaints (00:39:25) Using scan data and the ATG calculator to determine if a car has a power issue.The climbing subscription fees (00:43:19) Discussion on the possibility of group buys or legislation to address increasing subscription fees for tools.Nissan V2 repairs (00:45:40) Issues with repairing Nissan V2 vehicles, including the unavailability of certain parts and the need for extensive work.The problem with JLR devices (00:50:59) Discussion about the issues with JLR devices and the only devices that work for JLR diagnostics.Manufacturers locking out aftermarket tools (00:51:53) Clarification that no manufacturers are planning on locking out aftermarket tools, but security gateways may cause some functions to not work temporarily.Expert mode on VW Audi Snap-on Zeus (00:54:08) Advice on using expert mode on VW Audi Snap-on Zeus and the availability of interfaces and online scan tools for newer models.Problems caused by non-factory tooling (00:57:50) Discussion about the daily challenges of fixing BMWs due to problems caused by non-factory tooling.Remote programming and scam tool...