Everand Logo

Welcome to Everand!

  • Australian Woodsmith

    Build the SIDES

    Jul 29, 2020 2 minutes

    I’m not going to sugar-coat it, working with tapers can be a real challenge. But all the work you put into the legs will pay off as you start making the side panels and their supporting parts — the edging and rails.

    As the drawing above reveals, the tapered side panels are 19mm plywood. You’ll also notice that this taper, when viewed from the side, brings the front and

    You’re reading a preview, subscribe to read more.

    More from Australian Woodsmith

    Australian Woodsmith2 min read
    Sunshine Coast Wootha Prize Winners
    After the winners of the Tiny Treasures, Furniture and Sculpture prizes were announced the overall winner of the WOOTHA prize was made known. A very humbled and surprised Derek Calderwood made his way through the crowd in the Main Pavilion and accept
    Australian Woodsmith2 min read
    A New Angle on Chamfer Bits
    The router bit I use the most: a chamfer bit is the one I think about the least. On one hand that’s good because it means the bit does its job well. However, a little contemplation about your options can lead to better results in our projects. 45° IS
    Australian Woodsmith6 min read
    Reversible Glue Joint Bit
    Big panels can be a pain. Keeping all the pieces of a tabletop flush during a glueup can take almost every clamp in the workshop. And if that surface doesn’t end up entirely smooth, a planer won’t solve the problem. The only option then is to break o

    Related