OpenBSD on Microsoft Surface Go, FreeBSD Foundation August Update, What’s taking so long with Project Trident, pkgsrc config file versioning, and MacOS remnants in ZFS code.
##Headlines
OpenBSD on the Microsoft Surface Go

For some reason I like small laptops and the constraints they place on me (as long as they’re still usable). I used a Dell Mini 9 for a long time back in the netbook days and was recently using an 11" MacBook Air as my primary development machine for many years. Recently Microsoft announced a smaller, cheaper version of its Surface tablets called Surface Go which piqued my interest.


Hardware


The Surface Go is available in two hardware configurations: one with 4Gb of RAM and a 64Gb eMMC, and another with 8Gb of RAM with a 128Gb NVMe SSD. (I went with the latter.) Both ship with an Intel Pentium Gold 4415Y processor which is not very fast, but it’s certainly usable.
The tablet measures 9.65" across, 6.9" tall, and 0.3" thick. Its 10" diagonal 3:2 touchscreen is covered with Gorilla Glass and has a resolution of 1800x1200. The bezel is quite large, especially for such a small screen, but it makes sense on a device that is meant to be held, to avoid accidental screen touches.
The keyboard and touchpad are located on a separate, removable slab called the Surface Go Signature Type Cover which is sold separately. I opted for the “cobalt blue” cover which has a soft, cloth-like alcantara material. The cover attaches magnetically along the bottom edge of the device and presents USB-attached keyboard and touchpad devices. When the cover is folded up against the screen, it sends an ACPI sleep signal and is held to the screen magnetically. During normal use, the cover can be positioned flat on a surface or slightly raised up about 3/4" near the screen for better ergonomics. When using the device as a tablet, the cover can be rotated behind the screen which causes it to automatically stop sending keyboard and touchpad events until it is rotated back around.
The keyboard has a decent amount of key travel and a good layout, with Home/End/Page Up/Page Down being accessible via Fn+Left/Right/Up/Down but also dedicated Home/End/Page Up/Page Down keys on the F9-F12 keys which I find quite useful since the keyboard layout is somewhat small. By default, the F1-F12 keys do not send F1-F12 key codes and Fn must be used, either held down temporarily or Fn pressed by itself to enable Fn-lock which annoyingly keeps the bright Fn LED illuminated. The keys are backlit with three levels of adjustment, handled by the keyboard itself with the F7 key.
The touchpad on the Type Cover is a Windows Precision Touchpad connected via USB HID. It has a decent click feel but when the cover is angled up instead of flat on a surface, it sounds a bit hollow and cheap.


Surface Go Pen


The touchscreen is powered by an Elantech chip connected via HID-over-i2c, which also supports pen input. A Surface Pen digitizer is available separately from Microsoft and comes in the same colors as the Type Covers. The pen works without any pairing necessary, though the top button on it works over Bluetooth so it requires pairing to use. Either way, the pen requires an AAAA battery inside it to operate. The Surface Pen can attach magnetically to the left side of the screen when not in use.
A kickstand can swing out behind the display to use the tablet in a laptop form factor, which can adjust to any angle up to about 170 degrees. The kickstand stays firmly in place wherever it is positioned, which also means it requires a bit of force to pull it out when initially placing the Surface Go on a desk.
Along the top of the display are a power button and physical volume rocker buttons. Along the right side are the 3.5mm headphone jack, USB-C port, power port, and microSD card slot located behind the kickstand.
Charging can be done via USB-C or the dedicated charge port, which accommodates a magnetically-attached, thin barrel similar to Apple’s first generation MagSafe