The brilliant Dr. Russell Schafer joins Alan to talk about how he uses a 3D printer and digital design to find the middle ground between barely adequate treatment and the full Cadillac. Many times your patients have situations that don't allow for ideal treatment. Russell has found several situations where digital design and printing have made for a cost effective solution that works for his office AND his patients. Whether it's digital dentures, printed provisional crowns or short term orthodontics, in office 3D printing is filling a need that often goes unfilled in our offices. Some links from the show: NextDent 5100 Printer Blue Sky Bio Crown and Bridge module Microcopy Dental has always been the place to get the most amazing single patient use burs anywhere. But have you ever wondered why a person would want to go the "single patient use" route? Microcopy is offering 2 hours of free CE about this very issue at dentalhacks.com/freece! You'll see why dental burs should be single patient use for lots of reasons and you can pick up 2 CE's on infection control as well! Go check it out at dentalhacks.com/freece! It’s a weird fact of being a dentist...some patients don’t think they can come to the dentist without having some kind of insurance or benefits.  Instead of lamenting this fact, why not lean into it? Why not give them benefits? That’s where our friends at Boomcloud come in. BoomCloud has been helping people create and run membership plans in their offices since 2013. You need to check out Boomcloud for yourself. Jordan and our friends have put together the “Ultimate starter guide” for membership plans at dentalhacks.com/boomcloud.