TOOLS FOR ALL
Chain nose pliers
Round nose pliers
Wire cutters
Crimping pliers
E6000 or jewellers’ glue Ruler
VINTAGE BUTTERFLY CAMEO AND SWAROVSKI EARRINGS MATERIALS
2 x ear hooks silver
12 x 33mm head pins silver
2 x 6mm jump rings
2 x 4mm jump rings
2 x 18x13mm cameos
2 x 18x13mm brass settings
BEADS
12 x 4mm Swarovski bi-cones
VINTAGE BUTTERFLY CAMEO AND SWAROVSKI EARRINGS
STEP ONE
Apply glue to the back of each cameo and set inside cameo setting; put aside to dry.
STEP TWO
Thread all 12 Swarovski crystals onto the head pins, remove excess leaving a 1cm length from the top of the bead, bend wire at a 90 degree angle and create a basic loop at the top; do this for all 12.
STEP THREE
Open 6mm jump ring, thread on the cameo setting from Step 1 and thread six of the beads/head pins from Step 2 on to open jump ring; close.
STEP FOUR
Open 4mm jump ring, thread it through the 6mm jump ring; whilst open thread on ear hook, close jump ring.
STEP FIVE
Repeat Steps 3-4 to complete second earring.
CURLY SWAROVSKI BRACELET MATERIALS
8 x 30mm hollow beading curly tubes
6 x 6mm jump rings
1 x Swarovski head pin
2 x wire guards
2 x crimp beads
1 x hook clasp 60cm Tigertail
BEADS
5 x 6mm Swarovski bi-cones
18 x 3mm spacer beads
CURLY SWAROVSKI BRACELET
STEP ONE
Cut Tigertail into 2 x 30cm lengths.
STEP TWO
Slide on 1 x crimp going over both Tigertail ends; add 1 x wire guard, feed Tigertail through the wire guard and back down into the crimp; fold firmly using chain nose pliers, leaving a 2cm tail.
STEP THREE
Thread on 1 x 3mm round spacer followed by 1 x 6mm Swarovski bead, hiding tail of thread inside beads as you go, over both Tigertail wires.
STEP FOUR
Holding wire separated slide onto each 1 x 3mm spacer, 1 x curly tube, 1 x 3mm spacer,