Australian Woodsmith

Make a Staircase

Construction Overview / OVERALL DIMENSIONS: 1970mm H x 1815mm W x 950mm D

This project describes the construction of a set of simple steps, with newel posts, handrail balustrade and spindles. This formed part of a kitchen extension, and was subject to Building Regulations. The information presented here should provide you with the basis to customise a set of stairs to your own requirements.

The steps and risers are made from a water-resistant grade of MDF, with pine supports and side stringers. Using MDF is not only an economical choice, it is stable and will not "squeak" as the seasons change.

The assembly is held together with adhesive and screws. Jointing biscuits are used for attachments to the bottom of the stringers. The handrail and base rail use commercially available pine mouldings. These include a rebate to take 30 x 30mm cross section spindles. Newel posts were formed using 95 x 95mm DAR pine

You’re reading a preview, subscribe to read more.

More from Australian Woodsmith

Australian Woodsmith2 min read
HARDWARE & SUPPLIES SOURCES
Timbecon stocks the popular Freud Glue Line Profile Router Bit. Carbatec stocks two styles of glue line bits, a bargain basement Arden bit that will do the job and a premium CMT bit that will last for ages. The trick with using glue line bits is to c
Australian Woodsmith9 min read
Serpentine Chest
The serpentine style has a nearly four-century-old history, dating back to one of the most immoderate periods of French design. A traditional serpentine chest often featured ornate trim and gaudy carvings, and would look far more at home in the Palac
Australian Woodsmith7 min readArchitecture
Installing A Pre-hung Door
Hanging a door is one of the main tasks of a trim carpenter. Trim carpentry is woodworking on tour. Like a band on the road, working outside the controlled environment of the studio (or your workshop) presents new challenges. The main challenge being

Related