KNITTING INSTRUCTIONS
01 Top-down jumper
From page 14
Size:
36-38 (40-42) 44-46
Finished measurements:
Bust circumference: 108 (116) 124 cm
Length: 68 (69) 70 cm
Inner sleeve length: 25 (25) 25 cm
Material:
Austermann, Cotton Touch Recycled.
Content: 95 % cotton, 5 % other fibers.
50 g = 125 m.
7 (8) 9 balls – col 11 jeans
Knitting needles:
Circular needles size 3½ and 4 mm (40 and 60 cm)
Tension:
Tension 16 sts and 28 rows in basic pattern = 10 x 10 cm
Be sure to get the tension! (Change needle size if necessary)
The jumper is worked from the neckline downwards in one piece.
Border pattern:
Using needles size 3½ mm, k1, p1 in alternation.
Basic pattern:
Half-brioche st with knit-below st using 4 mm needles.
In rounds:
Round 1: *k1, p1*.
Round 2: *k1, inserting the needle into the st below (k1b), p1*.
In rows:
Row 1: selvedge st, *k1, inserting the needle into the st below, p1*, selvedge st.
Row 2: selvedge st, *k1, p1*, selvedge st. Repeat from * to *. Repeat rounds/rows 1 and 2 for pattern.
Raglan increase:
The marked st is a knit-below st; in every other rnd, work a yo on each side of this st. In the following rnd, work the yarnovers in the pattern (alternating k and p st).
Garter st in rnds:
Knit 1 rnd, purl 1 rnd in alternation.
Using the 3½ mm circular needle, cast on 92 st and join to work in the round. Work 8 rnds in the border pattern. Change to the 4 mm circular needle and work in garter st for 6 rnds. Then continue working in the basic pattern. After 1 rnd, mark the raglan st as follows: k1 = raglan st, work 13 sts for the left sleeve, k1 = raglan st, work 31 sts for the back, k1 = raglan st, work 13 sts for the right sleeve, k1 = raglan st, work 31 sts for the front. In the following rnd, work the first raglan inc as described above; then work raglan increases every other following rnd 25x (29x) 33x more = 300 (332) 364 sts. After working the last inc, work 1 more rnd without increasing. Then divide your work as follows: 66 (74) 82 sts for the left sleeve, 84 (92) 100 sts for the back, 66 (74) 82 sts for the right sleeve, 84 (92) 100 sts for the front. First continue working the sleeves in rows.
Work for 20 cm in the main pattern. Then change to the 3½ mm needles and continue working in the border pattern. When you have worked the border pattern for 5 cm, bind off all sts loosely in pattern. Work the 2nd sleeve in the same way.
Now continue working the front and back sts in rounds in the main pattern = 168 (184) 200 sts total. When you have worked for 30 (29) 28,5 cm, change to the 3½ mm circular needle and continue working in the border pattern. When you have worked the border pattern for 5 cm, bind off all st loosely in pattern.
Finishing
Dampen and block the pieces according to the measurements shown in the schematics; allow to dry. Sew the arm seams using the mattress st.
Design: Austermann
01 Schematics
02 Top-down cardigan
From page 13
Size:
36-38 (40) 42 (44-46) 48-50
Finished measurements:
Bust circumference: 104 (109) 118 (124) 138 cm
Length: 65 (65) 65 (65) 65 cm
Inner sleeve length: 45 (43) 41 (39) 37 cm
Material:
Austermann, Cotton Touch
Recycled
Content: 95 % cotton, 5 % other fibers
50 g = ca 125 m
9 (10) 11 (12) 13 balls – col 18 reed
Other supplies:
5 buttons, 22 mm
Knitting needles:
Size 3½ and 4 mm
Tension:
Garter stitch (RS and WS: knit) using size 4 mm needle. 18 sts and 30 rows = 10 x 10 cm.
Be sure to get the tension! (Change needle size if necessary)
Border pattern:
Stockinette stitch (RS: knit, WS: purl) using size 3½ mm needle.
I-cord edging – front:
You’re reading a preview, subscribe to read more.
Start your free 30 days