Everand Logo

Welcome to Everand!

  • Woodsmith

    READER Feedback

    Sep 03, 2019 3 minutes

    Yes on the CNC Router

    I have to take exception to Ray Weimer’s comment in issue No.

    244. Your article on the CNC router was one of the best I have ever seen in your magazine. I have almost completed the build and will send photos when done. Maybe I am alone here, but I found the CNC article created an awful lot more enthusiasm in my shop then another cutting board or cute box.

    You’re reading a preview, subscribe to read more.

    More from Woodsmith

    Woodsmith6 min read
    Leather Tool Bag
    The occasional quiet project in the shop is good for the soul. Turning off the saws, drills, and routers for a stretch of time is refreshing. And in the case of making the leather bag you see here, adding some leather working to your skillset is a go
    Woodsmith4 min read
    Pocket Mill Pro
    I can’t deny, there’s a part of me that never did stop getting excited about cool new toys. Over time that changed at some point from toy cars and LEGOs to power tools, chisels, planes, and all kinds of accessories. In the same vein though, there’s a
    Woodsmith7 min read
    Twisted Till
    Hand-crafted joints are always a thing of beauty. As a woodworker, I have a deep appreciation for the technical skill and understanding of the tools and materials one needs to make a clean joint by hand. Dovetails are often hailed as the pinnacle of

    Related