The Biqu Hurakan promises to make speedy 3D printing easy thanks to its built-in Klipper firmware, but its road has a few design potholes. Klipper is fast and accurate, and takes more horsepower than Marlin, the firmware normally installed on printers. Before the Hurakan – and the FLSun V400 – the only way to get Klipper was to install it yourself on a Raspberry Pi, then tether it to your
Biqu Hurakan
Apr 04, 2023
2 minutes
You’re reading a preview, subscribe to read more.
Start your free 30 days