3. SHELL PEARL, RUBBER AND STERLING SILVER NECKLACE AND EARRINGS MATERIALS
38mm x 3mm rubber tubing
1 pair 50mm head pins ball end SS
1 pair Sheppard ear hooks SS
60mm 19 strand stainless steel jewellery wire
2 x wire guardians SP
1 x lobster and jump ring SS
2 x crimps SS
BEADS
3 x 14mm shell based pearls
2 x 4mm rondelles Stardust SS
4 x 3mm rondelles Stardust SS
3. SHELL PEARL, RUBBER AND STERLING SILVER NECKLACE AND EARRINGS STEP ONE
Using wire thread 1 x crimp, going though wire guardian; adding clasp section to loop of guardian go back through crimp, finishing by folding crimp.
STEP TWO
Thread the following beads: 19cm rubber, 4mm, 14mm, pearl, 4mm and 19cm rubber.
STEP THREE
Finish second end as first with crimp and wire guardian.
STEP ONE – EARRINGS
Thread head pins with 3mm, pearl and a 3mm. Form a wrapped loop and attach to Sheppard hook by opening the loop on the Sheppard carefully and re-closing.
4. SHELL PEARL, RUBBER AND STERLING SILVER BRACELET MATERIALS
12cm x 3mm rubber tubing
50cm beading elastic
BEADS
3 x 14mm shell based pearls
3 x 8mm shell based pearls
6 x 4mm rondelles Stardust SS
6 x 3mm rondelles Stardust SS
4. SHELL PEARL, RUBBER AND STERLING SILVER BRACELET STEP ONE
Cut rubber tubing into 6 x 1.5cm lengths to fit 15cm wrist (cut longer if required to fit larger wrist).
STEP TWO
Use a scrap of wire as needle, fold elastic in half and thread the following design: 1.5cm rubber, 3mm, 8mm pearl, 3mm, rubber, 4mm, 14mm pearl, 4mm and rubber; repeat total of three times. Tie three overhand