Australian HiFi

LABORATORY TEST REPORT

Newport Test Labs measured the power output of the McIntosh MA252 as being 130-watts (21.1dBW) per channel at 1kHz, both channels driven into 8Ω, which is clearly much better than McIntosh’s specification of 100-watts per channel. A good 1.1dB better, in fact. Measured power output into the same load, but with a low-frequency test signal (20Hz) dropped by 0.7dB to 121-watts/20.8dBW. Again, an excellent result that was better than specification.

Measured into more demanding 4Ω loads, again with both channels driven, Newport Test Labs measured an output of 209-watts (23.2dBW) at 1kHz, with output again reducing very slightly at low frequencies, this time to 182-watts (22.6dBW) per channel at 20Hz. However, once again both these test results are higher than McIntosh’s own specification for a 4Ω load impedance, which is 160-watts per channel.

You can see from the tabulated results that when just a single channel

You’re reading a preview, subscribe to read more.

More from Australian HiFi

Australian HiFi2 min read
Leftovers Recipe
It's been 20 years since Shanling last launched a CD player, a small, blink-and-you'll-miss-it run of 300 units for the CD-T300 back in 2004. Now, the all-new CD-T35 is here to pick up where that left off — only this time round it is limited even fur
Australian HiFi2 min read
Flagship Tech For Less
HiFi Rose has a new integrated amplifier in its arsenal and, as is now expected from the Korean brand, it looks quite the stunner. The RA280 retains much of the same technology featured in the flagship RA180, whose intricate fascia turned more than a
Australian HiFi3 min read
Laboratory Test Report
The in-room frequency response of the Dellichord FR6, as measured by Newport Test Labs, is shown in Graph 1 and is the averaged result of nine measurements, made in a square grid with the tweeter at the central axis, using pink noise as a stimulus. Y

Related