Bamboo Fly Rod
I’ve been a woodworker and a fly fisherman for years, so it was probably inevitable that sooner or later I would build a bamboo fly rod. Inevitable, perhaps, but not necessarily a walk in the park. It cost me a fishing season. I broke rods long before they left the shop. I made rods that worked better as tomato stakes. I fried one rod to a crisp. I suffered epoxy failures and polyurethane busts. In short, I enjoyed every minute of it and, three rods after I started, I have a rod that I’m not ashamed to show to the world.
A bamboo fly rod is made of six strips of bamboo glued together to form a hexagon. The strips are triangular in cross-section, and since the rod tapers from handle to tip, the triangular strips taper, too — the triangle is bigger at one end of the strip than the other.
All of this is done in three stages: First, you rough out a rod blank, splitting the bamboo stem to stern, kiln-drying it, and then planing it into long triangular strips — a set of six strips for each section of the rod. In the second stage, you taper the triangular strips with a block plane and a special metal form. Then you apply glue to the pieces and clamp them together by
You’re reading a preview, subscribe to read more.
Start your free 30 days