Everand Logo

Welcome to Everand!

  • Woodcraft Magazine

    Tips & Tricks

    May 19, 2020 2 minutes

    TOP TIP

    Flush-routing risers

    I recently built a large slab table that required a lot of epoxy filling. I devised this router jig to help with the leveling of the hardened epoxy. The jig consists of four polycarbonate pieces screwed to a couple of maple risers as shown, creating a 1½ 6" opening in the center. To use the jig, I first outfit my router

    You’re reading a preview, subscribe to read more.

    More from Woodcraft Magazine

    Woodcraft Magazine2 min read
    Something Extra
    I enjoy living where I do in Eastern Pennsylvania where each season is distinct. The cold snows of winter slowly give way to warm spring afternoons. Then, the heat and humidity of summer are followed by the crisp, cool days of autumn. The change is r
    Woodcraft Magazine4 min read
    Benchtop Lathe STAND
    I first built a version of this stand when I was developing a turning program for the high school where I was teaching. I had enough money in my budget for five mini lathes and an assortment of tools, but not enough for stands. No worries. A few sket
    Woodcraft Magazine2 min read
    Reader Showcase
    Standing ovation. Maryland woodworker Caslow built a pair of Bent-Lam Guitar Stands (Apr/May 2023) for his two favorites—an Ovation and a Gibson. He used white oak, steam bending it around a form rather than laminating veneer strips to make the curve

    Related Books & Audiobooks