WORKSHOP TIPS
Feb 17, 2020
4 minutes
Mobile, Sturdy Light Stand
Good light is a must in every workshop, but sometimes I need a little extra light in just the right place. To make my light/magnifier more portable, I drilled a hole in a handscrew to fit the light’s post. Now I can clamp the light to any of my benches, stationary tools, or shelves.—Edward Hansen
Clamping Dowels
I recently made a couple boxes with finger joints. I didn’t have enough clamps to glue both boxes at once, so I decided to use band clamps. During my dry run, I discovered that the bands wouldn’t allow the joints to close. To fix this, I put a dowel on each side of each joint to keep the band clamp
You’re reading a preview, subscribe to read more.
Start your free 30 days